Crane Truck crane truck stands, it is a scalable system and through the hydraulic lift system to achieve cargo lifting, lifting and rotating device is, usually with truck mounted crane truck Used for assembly. It is composed of the chassis, power take-off device, crane, and cargo compartment of the truck. Crane manufacturers have XCMG cranes, stone coal, Yutong Heavy Industry, and other manufacturers, operating methods can be about two-way operation, hand throttle can be adjusted to the speed of rotation and lifting speed. So how should the rope truck with the crane connect? Different types of truck cranes have different types of rope card connections. The connection method also has a detailed decision with the mode and object of work. When the vehicle is in use, the net distance of the inner side of the U-shaped ring is generally larger than the diameter of the steel wire rope, and the rope groove of the rope card seat should be aligned with the direction of the steel wire rope. It is basically consistent with the surface. Then, the following instructions for use must be taken into account during the use of the vehicle. 1. The rope clamp of the truck crane should be as close to the collar as possible, and it is necessary to better confirm that the rope clamp is properly tightened. In the position of the rope head, be sure to use a thin wire to bind firmly. 2. It should be noted here that the direction of the ropes on the same rope is required to be the same, that is to say the contact between the ropes and the U-shaped parts and the contact between the main ropes and the deck. If the main rope is in contact with the U-shaped part, if the wire rope is squashed, it is relatively easy to break the wire when subjected to stress. 3. The rope card above the crane should be tightened firmly until the wire rope is flattened. Use nut and rope clamp to fasten it, so as to ensure the connection stability of the connector. 4, in order to be able to more aspects of the inspection to the joint position is not completely stable, and whether there is no sliding rope situation, you can place a safety bend in the position of the rope, if it is in the process of using the crane condom was suddenly After straightening, there is a slippage in the wire rope that has surfaced the joint. Remedial measures should be taken immediately to avoid any safety accident. Flow Meter,Plastic Tube Flow Meter,Industrial Flow Meter,Gas Flow Meter Ruian Kaijun Trade Co., LTD , https://www.kaijuntrade.com