If you need to re-open the air conditioner after turning off the air conditioner, do not hurry and open it quickly. You should wait for two to three minutes before you can turn it on again. Otherwise, it will damage the compressor. And is or short of its useful life. Even in seasons in which high-pressure cleaner cars are not often used, it is necessary to turn on air conditioners and allow them to operate normally for about ten minutes in order to increase the lifespan of vehicle air conditioners. When the high-pressure cleaning vehicle shifts gears, it is necessary to fully step on the clutch pedal before the vehicle can shift gears. When the vehicle shifts from forward gear to reverse gear, it should be operated only when the vehicle is completely safe. When the gear lever is set to the reverse gear, the reverse lamp should be turned on and the reverse beep. The siren also needs to be turned on so that pedestrians and past vehicles can be alerted. The transmission gear of the high-pressure cleaning vehicle is also in many forms. The driver of the vehicle can make relevant queries according to his own vehicle. The form of the parking brake can be divided into two states. The driver of the vehicle should use the parking brake of his own model. Actually perform related operations for correct operation. When the vehicle stops, pull up the hand brake lever until it reaches the locked position, and the vehicle needs to be released when starting the vehicle. You should pull up the locking sleeve of the operating lever before it can be pulled forward. Hand-operated joystick, (the problem to be clearly stated here is that it is not possible to release the parking brake if the pressure is relatively low) and then pulls the parking brake lever all the way to the end. When the operating lever is pulled up slightly, the button at the end of the operating lever can be depressed, and the operating lever can be pushed straight down again. The parking brake's joystick also has two forms. It is also required to carry out relevant inquiry according to the purchased high pressure cleaning vehicle . After releasing the lock stem, the steering wheel of the vehicle can be adjusted up and down along the axial direction. And before and after the tilt adjustment, before the steering wheel adjustment, the driver can adjust the seat according to their own needs, and then after adjusting the steering wheel, in the re-locking the steering wheel adjustment mechanism to avoid driving the vehicle in the process, The position of the steering wheel will change by itself. Note: When the steering wheel is adjusted, the high pressure cleaner should be in a stopped state. (Text / Sun Ni) Motorcycle Mould,Auto Mould,Auto Parts Mould,Auto Plastic Injection Mould Kunshan Wangdaxin Precision Mould Co., Ltd. , https://www.wdxmould.com
